Programming Instructions; Certificate Of Installation; Troubleshooting - Viper 106V Installation Manual

programming instructions

Use the procedure below to program touch-keys into the system. A maximum of 3
touch-keys can be programmed into the system.
N N O O T T E E : : In order to program touch-keys into the system, the sys-
tem must be disarmed.
1. Turn the ignition On then Off 12 times.
2. The LED will illuminate continuously.
3. Insert the touch-key to be programmed into the touch-key receptor.
4. The LED will turn Off for 1-second and then back On continuously. The touch-
key is now programmed.
5. After 15 seconds of no activity the LED will extinguish and the system will exit the
programming routine.
N N O O T T E E : : If more than one touch-key is required to be programmed,
then repeat steps 3 and 4 after the first touch-key is programmed.

certificate of installation

After installation you must fill out the certificate of installation. Once you have filled
out all information on the certificate the customer must sign and date it. Distribute the
copies as follows:
White (top) copy - customer
Blue copy - customer's insurance broker
Pink copy - Directed Electronics, UK office
Green copy - installing dealer

troubleshooting

The Touch-Key does not work.
Make sure that the harness is plugged in. (Refer to the wiring reference guide.)
Has the Touch-Key been programmed to the system.
The system does not work (no LED illumination).
Check the fuse in the power harness.
8
www.directed.com