Clifford Concept 650MkII Installation Manual page 11

armed, this wire will trigger the system.
h1/14 green (-) door trigger input - zone 4
Most vehicles use negative door trigger circuits. Connect the GREEN wire to a wire
showing ground when any door is opened. When connecting to newer model vehicles
there is sometimes the need to use individual door trigger wires. This wire will report
Zone 4.
N N O O T T E E : : If using a door trigger wire that has a delay, the installer-selectable program-
ming grid or the Cliffnet Wizard can be used to turn the door ajar warning off.
(-) DOOR SWITCH
h1/15 green/white normally closed input - zone 6 (pre-connected to h1/5)
This wire is pre-connected to ground on H1/5. Some vehicles are factory fitted with
normally closed bonnet pin switches which can be connected to this wire. Or alterna-
tively, it can be connected to ground after being looped through external ancillary
equipment such as mountain bikes, spot lamps, spare wheels, in-dash CD players, etc.
The input can also be used for connection to a heated rear window switched wire.
This last option is especially useful as if the rear windscreen was removed whilst the
alarm was armed the alarm would trigger.
h1/16 blue (-) boot input - zone 5
This input will respond to a negative input with an instant trigger. Connect to (-) boot
pins and it will report on Zone 5.
h1/17 black/white interior light illumination output (30)
Connect this wire to the interior light circuit trigger wire or the alarm's door trigger
input wire H1/4 or H1/14. When the alarm is disarmed this wire will provide an out-
put to turn on the interior light for 30 seconds.
h1/18 black/white interior light illumination input (87)
This wire determines the output of the BLACK/WHITE H1/17 wire on the main 18-pin har-
ness. If the vehicle has a negative switched interior light circuit, ground this wire; if the vehi-
© 2007 directed electronics
INTERIOR LIGHT
GREEN
(+) 12V
9