Operating-Settings Learn Routine - Viper 500HF Installation Manual

Many of the operating settings of this unit are programmable. They can be changed whenever necessary through
a computer-based Learn Routine
the module must be in the learn position (see page 9). The Valet
blue port is used together with a programmed transmitter to change the settings. To program settings remember:
Door, Key, Choose, Transmit and Release.
1. Door
2. Key
3. Choose
Feature Number
1
2
3
4
5
6
7
8
9
10
11
12
18

OPERATING-SETTINGS LEARN ROUTINE™

™ . In order to access Learn Routine
Open a door. Either the H1/5 green or the H1/7 violet door trigger
wire must be connected for the control unit to "see" an open door.
Turn the ignition on and then back off. The H1/9 yellow
switched ignition input must be connected.
Within 15 seconds, press and release the Valet
the number of times corresponding to the number of the
desired feature (see the chart below). The one chirp settings
below are the factory default settings, except where indicated by
bold text.
One-chirp setting
Active arming
Arm/disarm chirps on
Ignition-controlled door locks
Active locking only
Panic with ignition on
0.8 second door lock pulses
Forced passive arming on
Automatic engine disable on
VRS enabled
®
Code Hopping™ on
Siren
Standard unlock pulse
™ , the jumper underneath the sliding door on
® /Program push-button switch, plugged into the
® /Program button
Two-chirp setting
Passive arming
Arm/disarm chirps off
Standard door locks
Passive locking
No panic with ignition on
3.5 second door lock pulses
Forced passive arming off
Automatic engine disable off
VRS disabled
®
Code Hopping ™ off
Horn honk
Double unlock pulse
© 1998 Directed Electronics, Inc. Vista, CA
N438 7/98