Viper 500HF Installation Manual page 19

Once the button has been pressed and released the correct number of times press it once more and hold it. After
a second, the siren will chirp to indicate what step you have accessed. For example, three chirps would indicate
access to the ignition controlled door lock feature.
For example, to program the arming mode from active to passive, press and release the Valet
once. Then press and hold it. The siren will chirp once, indicating that the setting can now be changed. While
holding the Valet ® /Program button, press the arm/disarm button on the transmitter. The siren will chirp twice to indi-
cate that passive arming has been programmed. If this is the desired setting, release the Valet
If this is not the desired setting, continue to hold the Valet
the transmitter again. The siren will chirp once indicating that active arming has been programmed. Once the
desired setting has been selected, release the Valet
You can advance from step to step by pressing and releasing the Valet
essary to get from the step you just programmed to the step you wish to access. If you just programmed the
arm/disarm chirps to off and you want to program passive locks, release the Valet
release it twice to step from feature two to feature four. Then press it once more and hold it. The unit will chirp four
times to confirm that you have accessed feature number four.
The Learn Routine ™ will be exited if:
• The ignition is turned on.
• The door is closed.
• The Valet ® button is pressed too many times.
• More than 15 seconds elapses between steps.
The siren will emit a long chirp when Learn Routine
© 1998 Directed Electronics, Inc. Vista, CA
19
N438 7/98
4. Transmit While holding the Valet
the arm/disarm button of the transmitter, to toggle
between the one and two chirp settings. The one-
chirp settings are the factory defaults.
5. Release The Valet
® /Program button.
™ is exited.
® /Program button, use
® button can now be released.
® /Program button and press the arm/disarm button on
® /Program button the number of times nec-
® /Program button
® /Program button.
® /Program button, press and