Satellite Radio Operation - Jensen VM8013HD Installation And Operation Manual

~\S!3>
VM8013HD
SATELLITE RADIO OPERATION
Listeners can
subscribe to X~ Radio
on the Web by visiting
www.xmradio.com. or by calling (800) 967-2346. Customers should
have their Radio ID ready (see "Displaying the Identification (lD)
Code''). Customers can receive a limited number of free-to-air
channels without activation.
Accessing Satellite Radio Mode
Press the SRC button (6) on the front panel or remote control (14) to switch
to the SAT source.
CHAN: XM Preview
P1 XM Preview
P2 XM Preview
1. SAT Channel Name
2. SAT Channel Number
3. SAT Band
4. lime/Clock
5. Artist and litle Information
6. Current Preset Channels
7. Source Indicator
Displaying the Identification (ID) Code
Before you listen to satellite radio, you must subscribe to the service using
your radio's identification number. To display the radio 10, press the DISP
button three times or use the
1«
tuning button (17) to tune to channel "000".
The screen displays the radio 10 where the channel name is usually
displayed.
10
select a Band
Press the BAND button (3) to change between three SAT bands (SAT1,
SAT2 and SAT3). Each band stores up to six preset stations.
Selecting a Station
Press the
»1
or
1«
tuning button (17) to tune to another station.
Preset Mode
Six numbered preset buttons store and recall stations for each band. All six
stored stations (P1-P6) for the current band can be viewed on the screen.
Use the remote control up/down arrow buttons (5) to scroll through the list.
Storing
a
Station
1. Select a band (if needed), then select a station.
2. Press and hold a preset button (numbers 1-6) on the front panel or
remote control.
3. The preset number and station appears highlighted.
Recalling
a
Station
1. Select a band (if needed).
2. Press a front panel or remote control preset button (numbers 1-6) to
select the corresponding stored station.
Channel Search
To access Channel Search mode, press the DlSP button (7). The list of all
available channels appears on the screen.
1. Rotate the VOUSEUMENU rotary encoder (2) on the control panel or
press the up/down arrow keys (5) on the remote control to navigate the
list of channels.
2. Press the VOUSEUMENU button on the control panel or the ENTER
button (6) on the remote control to select a channel.