Related Manuals for Jensen VM8013
Summary of Contents for Jensen VM8013
- Page 1 VM8013 Installation and Operation Manual DISP BAND iPod Menu A/V IN Watts Peak Watts en Crête Vatios el Máximo 40W x 4...
-
Page 3: Table Of Contents
VM8013 TABLE OF CONTENTS Introduction ...1 Installation ...1 Wiring ...3 Front Panel Release ...4 Remote Control ...5 Operation ...7 Satellite Radio Operation ...10 Radio Operation ...12 DISC/MP3/WMA Playback ...14 Controlling Your iPod ...18 Setup Menu ...19 Care and Maintenance ...20 Troubleshooting ...21... - Page 4 VM8013...
-
Page 5: Introduction
1. Disconnect Battery Before you begin, always disconnect the battery negative terminal. NOTE: If the VM8013 is to be installed in a car equipped with an on- board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. -
Page 6: Reconnect Battery
If the removal keys are inserted at an angle, they will not lock properly and will not release the unit. Technical Assistance If you require assistance, contact Technical Support at 1-800-323-4815 from 9:00am to 6:00pm EST Monday through Friday. VM8013... -
Page 7: Wiring
VM8013 WIRING SAT BUS Compatible SAT Tuners: 1. XMD1000 (requires XMC or XMDJEN100 Cable Kit) 2. CNP2000UC 3. SC-C1 and SIRJEN2 NOTE: The amplifier in this radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. -
Page 8: Front Panel Release
1. With the panel laying flat (in the “open” position), insert the left side of the panel in place until correctly engaged. 2. Gently press the right side of the panel until the mechanism locks it into place. 3. Lift upward to close the panel. VM8013... -
Page 9: Remote Control
VM8013 REMOTE CONTROL The remote control will allow you to control the advanced functions of the VM8013. Operating Range The remote control sensor (19) is located near the bottom of the front panel, left of the LCD screen. The remote control can operate within a distance of 3~5m. - Page 10 VM8013 Button Tuner ZOOM TITLE Power Power On Press and hold to Power Off SETUP Display Setup Menu Navigation Arrows Down/Up (Left returns to pre- vious menu screen) ENTER Confirm Entry CLEAR Direct Entry Audio Mode: Select BAS, TRE, BAL, FAD.
-
Page 11: Operation
“0” (lowest) to “40” (highest). SWC Interface (Optional) The VM8013 is compatible with PAC (Pacific Accessory Corporation) adapter SWI-PS steering wheel control interface. A 3.5mm female connector (labeled SWC Interface) on the back of the head unit is used to connect to the SWI-PS adapter. - Page 12 3. Press the VOL/SEL/MENU button (2) to confirm and move to the hour field. 4. Turn the VOL/SEL/MENU rotary encoder to set the hour. 5. Press the DISP button to set the clock and exit the clock set function. VM8013...
- Page 13 VM8013 Reset Button The RESET button is located behind the front panel and can only be accessed with the front panel opened. Resetting the unit will erase the time and preset memories. It should only be activated upon initial installation after all wiring is complete, or if there is a malfunction of any of the switches on the unit.
-
Page 14: Satellite Radio Operation
1. Rotate the VOL/SEL/MENU rotary encoder (2) on the control panel or press the up/down arrow keys (5) on the remote control to navigate the list of channels. 2. Press the VOL/SEL/MENU button on the control panel or the ENTER button (6) on the remote control to select a channel. VM8013... - Page 15 VM8013 Category Search 1. To access Category Search mode, press the DISP button (7) twice. The list of available categories appears on the screen. CH001 CHAN: XM Preview News Sports Title: www.xmradio.com 2. Rotate the VOL/SEL/MENU rotary encoder (2) on the control panel or press the up/down arrow keys (5) on the remote control to navigate the list of categories.
-
Page 16: Radio Operation
Repeat for the remaining five presets on the current band and for presets on the other four bands. Preview Scan Press the each. Press button (16) to scan and play all strong stations for 5 seconds again to stop scanning and play the current station. VM8013... - Page 17 VM8013 Automatic Store (AS) Press and hold the button (16) to select six strong stations and store them in the current band using the Auto Store feature. After entering the stations into memory, the unit will automatically stop at each station for five seconds, allowing you to preview each selection.
-
Page 18: Disc/Mp3/Wma Playback
Many types of software are available for converting audio files into MP3/ WMA formats. Jensen recommends Nero or Roxio Easy CD Creator. button to flip the front This unit can play MP3 (MPEG1, 2, 2.5 Audio Layer 3). However, the MP3 recording media and accepted formats are limited. - Page 19 Folder Search, File Search or Folder Select as shown below. The VM8013 player will only recognize three folder levels and does not display folders containing only other folders. In the example above, the unit will display folders 3, 4, 6, and 8, but not 2 and 7 since they do not contain any tracks directly.
- Page 20 MP3/WMA: Repeat File, Repeat Directory/Folder, Repeat All (disc), Repeat Off Random (RDM) Press the 4/RDM button (11) during playback to select “RANDOM” and play all tracks/files in random, shuffled order. Press 4/RDM again to stop random play. VM8013 symbol. When the...
- Page 21 1/6, or 1/8 speed. Press the play/pause >/|| button (8) to end fast forward or reverse and resume normal playback. NOTE: Feature availability is dependent on DVD embedded information. NOTE: The VM8013 does not support Surround Sound decoding. buttons on the remote...
-
Page 22: Controlling Your Ipod
Release to resume normal playback. Photo/Video Playback While iPod photos and videos can be viewed on the VM8013 screen, you must use the iPod to control photo and video playback options. Press the TITLE button (2) on the remote control and the VM8013 will release control back to the iPod so you can select video media to be displayed on the TFT monitor. -
Page 23: Setup Menu
VM8013 SETUP MENU During disc play, press the SETUP button (4) on the remote control to access the SYSTEM SETUP menu. SETUP MENU LANGUAGE VIDEO RATING MISC Language Menu Use the cursor buttons to choose between LANGUAGE, VIDEO, AUDIO, RATING or MISC setup options. -
Page 24: Care And Maintenance
5. Carefully wipe fingerprints, dust and dirt from the disc’s playing surface with a soft cloth. Wipe in a straight motion from the inside to the outside of the disc. 6. Do not stick paper, tape or disc labels on disc surfaces, as internal damage may occur. or NERO burning VM8013... -
Page 25: Troubleshooting
VM8013 TROUBLESHOOTING Problem Cause Does not operate (display No power to yellow wire; no power does not light) to red wire Fuse blown No power to unit Fuse blown No/low audio output Improper audio output connection Volume set too low... -
Page 26: Specifications
DIN Chassis Dimensions..... 7" X 7" X 2" (178mm x 178mm x 50mm) *Specifications subject to change without notice. VM8013... -
Page 27: Limited Warranty
Limited Warranty CD or Multimedia Radios/Headunits Audiovox Electronics Corporation (“the Company”) is committed to quality and customer service, and are pleased to offer you this Warranty. Please read it thoroughly and contact the Company at 1-800- 323-4815 with any questions. Who is covered? The Company extends this warranty to the original retail purchaser of products purchased through an authorized Audiovox retailer in the U.S.A., Puerto Rico or... - Page 28 Audiovox Electronics Corporation Hauppauge, NY 11788 Technical Assistance: 1-800-323-4815 www.jensen.com © 2008 Audiovox Ver. 033108 Printed in China...