Configure Router Ospf Area Virtual_Link Dead_Interval - Alcatel Router User Manual

Running H/F 2

configure router ospf area virtual_link dead_interval

This command sets the time, in seconds that an OSPF neighbor will wait for a hello packet.
Once the user-defined time expires, the interface assumes that the neighbor is down. The value
entered should be approximately four times the value of the hello_interval.
parameter
dead_interval
syntax:
[ no ] dead_interval < n >
example:
- /configure/router/opsf/area 1/virtual_link 100.10.1.5> dead_interval 10
Alcatel host
related commands
configure router ospf area virtual_link authentication
configure router ospf area virtual_link hello_interval
configure router ospf area virtual_link retransmit_interval
configure router ospf area virtual_link transmit_delay
applicable systems:
All models.
definition
The time in seconds.
The value configured must be the same for all routers and servers in the same network.
The range is 1 - 65535; the default value is 40.
The recommended value to configure is four times the value configured for the hello
interval.
#
Router User Guide