Multi-Level Security Arming - Viper 600 ESP Installation Manual

multi-level security arming

Multi-Level Security Arming is a feature that allows you to select which of the security system's inputs or sensors
will be active and which will be bypassed at the time that the system is armed. (See Table of Zones section in
this guide.) Pressing the arm button (only on a Standard Configuration transmitter) again within five seconds of
arming the security system will activate the Multi-Level Security Arming feature. Each time the arm button is
pressed again, a different security level is selected. The different security levels can be selected as follows:
Pressing one time: The siren chirps once. The system is armed.
Pressing a second time within five seconds: The siren chirps twice followed by a long chirp. Zone Two is
now bypassed.
Pressing a third time within five seconds: The siren chirps three times followed by a long chirp. Zone Four
is now bypassed.
Pressing a fourth time within five seconds: The siren chirps four times followed by a long chirp. Zones
Two and Four are now bypassed.
Pressing a fifth time within five seconds: The siren chirps five times followed by a long chirp. All input
zones, except the ignition, are now bypassed.
NOTE: Multi-Level Security Arming only applies to a single arming cycle. Once the system is disarmed
and then re-armed, all the zones will be active again.
38
© 1999 Directed Electronics, Inc. Vista, CA