Handling
This chapter describes basic handling of the printer.
Charging Battery
Follow the steps below to charge the battery. You can charge the battery using the printer itself
with the optional power unit (Model: PS-11).
Be sure to use the battery OT-BY60II.
Using a battery other than the one specified may cause fire, explosion, leakage, overheat-
ing or other damage.
WARNING
• The battery can be charged only when the temperature is 0 ~ 40°C {32 ~ 104°F}.
• Dispose of used batteries according to the instructions.
• Do not remove the battery during charging.
• Fully charging a battery that is fully discharged while the printer is turned off will take
• Charging the battery at 35°C {95°F} or higher may require a longer charging time than
• You can use the printer during the battery charging.
• For information on the optional power unit (Model: PS-11), see its User's Manual.
1
Install the battery.
See
"Installing Battery" on page
2
Connect the optional power unit to the connector for the power unit.
Charging starts. The Charge LED flashes while charging the battery.
approximately 2.5 hours.
the specified one.
38.
Chapter 4 Handling
4
73