Radio Field Intensity Check Mode (Only For Wi-Fi Models); Radio Field Intensity Check Mode (Only For Wi-Fi Models) - Epson TM-P60II Technical Reference Manual

Radio Field Intensity Check Mode (Only For Wi-Fi Models)

In the radio field intensity check mode, the printer prints information about the wireless LAN
intensity.
Starting the field intensity check mode
Follow the steps below to run this mode.
1
Install the roll paper.
2
Close the roll paper cover.
3
While pressing the Feed button, turn the power on. (Keep pressing the
button until the printer starts printing.)
The printer starts printing the current status of the printer.
When the printer finishes printing the printer status, the following message is printed and
the Paper LED flashes. (The printer is now in the self-test wait mode.):
4
Press the Feed button. (Keep pressing the button until the printer starts
printing.)
The printer starts printing instructions.
5
After the printing has been completed, press the Feed button 3 times.
6
Press the Feed button again. (Keep pressing the button until the printer
starts printing.)
The printer starts printing instructions. Follow them.
Turn the power off and on to return to the normal mode.
Chapter 3 Application Development Information
"Select Modes by pressing Feed button.
Continue SELF-TEST: Less than 1 second
Mode Selection : 1 second or more"
3
71