Valet Mode; Timer Mode - Viper 771XV Installation Manual

and rearmed, and still allow NPC to bypass a faulty zone.
When disarming the system, 5 chirps indicate NPC is activated. The LED will report the zone that has been
bypassed. (See Diagnostics section of this guide.)
v v a a l l e e t t m m o o d d e e
T T o o e e n n t t e e r r o o r r e e x x i i t t v v a a l l e e t t m m o o d d e e w w i i t t h h t t h h e e v v a a l l e e t t / / p p r r o o g g r r a a m m s s w w i i t t c c h h : :
1. Turn the ignition key on and then off.
2. At anytime during the next 10 seconds, press and release the Valet switch. Now the Status
LED will light constantly if you have entered Valet Mode, and go out if you have exited

Valet Mode.

T T o o e e n n t t e e r r o o r r e e x x i i t t v v a a l l e e t t m m o o d d e e w w i i t t h h t t h h e e t t r r a a n n s s m m i i t t t t e e r r : :
To enter or exit Valet Mode with a transmitter:
1. Open any door.
2. Press on the transmitter.
3. Press .
4. Press again. You have now entered or exited Valet Mode (verify by checking your status LED).
t t i i m m e e r r m m o o d d e e
This unit can be programmed to start and run the engine every three hours, for a maximum of six cycles. The
engine will run for the programmed run time and then shut down. After three hours, the system will restart the engine.
I I M M P P O O R R T T A A N N T T ! ! Timer Mode should be used only in open areas. Never start and run the vehicle in
an enclosed space such as a garage or carport.
T T o o e e n n t t e e r r o o r r e e x x i i t t t t i i m m e e r r m m o o d d e e w w i i t t h h t t h h e e t t r r a a n n s s m m i i t t t t e e r r : :
The same procedure may be used to enter or exit Timer Mode using the remote transmitter:
1. Remote start the vehicle by pressing
© 2005 Directed Electronics—all rights reserved
and simultaneously.
5 5 1 1