Viper 771XV Installation Manual page 23

H H 2 2 / / 3 3 G G R R E E E E N N / / W W H H I I T T E E ( ( - - ) ) f f a a c c t t o o r r y y a a l l a a r r m m r r e e a a r r m m
This wire sends a negative pulse every time the remote start shuts down or the doors are locked. This can be
used to pulse the arm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the
arm wire.
H H 2 2 / / 4 4 V V I I O O L L E E T T / / B B L L A A C C K K c c h h a a n n n n e e l l 4 4 o o u u t t p p u u t t
This wire provides a (-) 200mA output whenever the transmitter button(s) controlling Channel 4 is pressed. This
output can be programmed to provide the following types of outputs (see also the Feature Menus section):
■ V V a a l l i i d d i i t t y y : : Output that will send a signal as long as the transmission is received.
■ L L a a t t c c h h e e d d : : Output that will send a signal when the Channel 4 button(s) is pressed and will continue until the
same button(s) is pressed again.
■ L L a a t t c c h h e e d d , , r r e e s s e e t t w w i i t t h h i i g g n n i i t t i i o o n n : : Similar to the latched output, this type of output turns on the first time the
Channel 4 button(s) is pressed and turns off the next time the same button is pressed. This type of output
additionally stops and resets whenever the ignition is turned on and then off.
■ 3 3 0 0 - - s s e e c c o o n n d d t t i i m m e e d d : : Output that will send a continuous signal for 30 seconds.
© 2005 Directed Electronics—all rights reserved
2 2 3 3