Transmitter Configurations - Viper 771XV Installation Manual

5.
You can advance from one channel to another by releasing the Valet/Program button and tapping it to advance
channels and then H H O O L L D D I I N N G G it. For example, if you want to program Channel Three after programming Channel One,
release the Valet/Program button. Press it twice and release it to advance to Channel Three. Then press it once more
and H H O O L L D D it. The siren will chirp three times to confirm it is ready to receive the code from the transmitter.
Learn Routine™ will be exited if:
■ Ignition is turned off.
■ Door is closed.
■ Valet/Program button is pressed too many times.
■ More than 15 seconds elapses between steps.
One long chirp indicates that Learn Routine™ has been exited.
t t r r a a n n s s m m i i t t t t e e r r c c o o n n f f i i g g u u r r a a t t i i o o n n s s
The transmitters can be programmed with the standard or custom configurations by using the
Transmitter/Receiver Learn Routine.
s s t t a a n n d d a a r r d d c c o o n n f f i i g g u u r r a a t t i i o o n n
A remote that uses the standard configuration operates similarly to many factory keyless entry remotes. A stan-
dard configuration transmitter allows arming, disarming, and Panic Mode activation with separate buttons. When
programmed for standard configuration, the transmitter buttons are assigned to the following functions:
3 3 8 8
R R e e l l e e a a s s e e . . Once the code is learned, the Valet/Program button can be released.
.................................operates ...........................Arm/Lock,
.................................operates ...........................Disarm/Unlock,
.................................operates ...........................Start
.................................operates ...........................Channel 2—trunk
Panic ON/Panic OFF
/Panic OFF
© 2005 Directed Electronics—all rights reserved