Jacuzzi SALON SPA BATH SERIES Installation And Operation Instructions Manual page 14

Drop-in Installation (con't)
Install the unit, inserting the equipment- end first,
8
lowering the bathtub into the opening as shown in
the illustration (Figure 10).
DO NOT use plumbing fixtures or lines to lower the
unit. Allow the bathtub to rest on the supports.
Inspect all fittings, plumbing, and control lines
9
after inserting to insure the components are not
damaged, disconnected, or contacting the finish
surface substrate or support members.
Connect flex water supply lines to faucet and plug
10
power cords into GFCI outlet.
Remove scrap lumber and lower the bathtub fully
11
into the opening (Figures 11 and 12).
Align the bathtub and connect the drain.
12
Turn on the power supply to the dedicated GFCI
13
protected circuits and check system operation.
Caulk around the perimeter of bathtub to seal
14
the space between the rim and the finished deck
(Figure 8 on previous page).
Page 14
Level Subfloor
Level Subfloor
Uneven
Subfloor
www.jacuzzi.com
Salon™ Spa Bath
Scrap Lumber
2˝
(50mm) Max
Thickness Substrate
Member Support
Figure 10
Figure 11
Figure 12
Installation and Operation
Tile or
Finished
Surface
Floating
Floor
Compound