Table of Contents
Advertisement
5.2b THREE-WAY INTERCOM
Both scala rider G9 PowerSet units are factory-paired and configured
to communicate via their respective Channel "A" Buttons. To pair a
third scala rider G9 use Channel "B".
To set up three-way intercom conference mode proceed as
follows:
Rider 2
Rider "1" is paired to Rider "2" and also to Rider "3".
PAIRING THREE SCALA RIDER G9 UNITS
1. Rider 1 pairs their device to Rider 2 using Channel "A" as
described in section 5.2a.
2. Rider 1 pairs their device to Rider 3 using Channel "B" as
described in section 5.2a.
The Three-Way Conference Intercom Pairing is now complete and
ready to use.
IMPORTANT: Three-Way Conference Mode Considerations
During a 3-Way Intercom Conference call with 2 other participants,
Rider 1 will not be able to receive mobile phone calls or GPS
navigation instructions as long as the call is in progress.
|
scala rider
G9 / G9 PowerSet
®
12
Rider 3
Rider 1
5.2c FOUR-WAY INTERCOM
To set up four-way intercom conference mode proceed as follows:
In this configuration the two passengers (numbered 2 and 4) are
each using two Bluetooth connections:
Passenger 2 is paired to Rider 1 and to Passenger 4
Passenger 4 is paired to Rider 3 and to Passenger 2
PAIRING FOUR SCALA RIDER G9 UNITS
1. Pair Rider 1 to Passenger 2 using Channel "A" (see 5.2a).
2. Pair Rider 3 to Passenger 4 using Channel "A" (see 5.2a).
3. Pair Passenger 2 to Passenger 4 using Channel "B" (see 5.2a).
The Four-Way Pairing is complete and ready to use.
IMPORTANT: Four-Way Conference Mode Considerations
During a 4-Way Intercom call, the two passengers who maintain two
active connections simultaneously will not be able to receive mobile
phone calls or GPS instructions as long as the conference call is in
progress.
Advertisement
Table of Contents
