Liquid Propane Cylinder Connection; Hose To Cylinder Connection; Check For Gas Leaks - Weber 300 Owner's Manual

A) Remove the plastic dust cover from the tank valve.
B) Screw the hose coupling onto the tank valve, turning clockwise, or to the right
Hand-tighten only.
Note: This is a new type of connection. It tightens clockwise and will not allow gas to
flow unless the connection is tight. The connection requires tightening by hand only.
To turn the burner valves off, push both control knobs in and turn clockwise. When knobs
cannot be turned further, confirm that they are both set to the OFF position. Proceed to
the next step.
A) Mix soap and water.
B) Turn on the cylinder valve by turning cylinder valve handwheel counter-clockwise
C) Check for leaks by wetting the fittings with the soap and water solution and watching
for bubbles. If bubbles form, or if a bubble grows, there is a leak.
GAS INSTRUCTIONS
.
.
®
1
2
3
WWW.WEBER.COM
® 25