Table of Contents
Advertisement
RADION receiver OP
bank vault at the close of each business day. In this scenario, the bank vault system is always
armed, and the bill trap remains in a non-faulted condition. It is recommended to use the 3M
double sided tape when inserting into the cash drawer.
In other occasions, the bill trap itself may be removed from the cash drawer at the end of a
workers shift. In this situation, the bill trap unit will generate a tamper condition upon
removal. In this type of application, it is important that the system must be configured such
that the tamper does not generate a silent alarm. For this occasion, the hook and loop may be
a more suitable mounting technique.
12.2
Installation consideration
During the installation process, use the self-adhesive Velcro strips located on the bottom of
the bill trap base, to secure and stabilize the bill trap in the cash drawer. This is achieved by
performing the following:
1.
2.
3.
4.
Warning!
!
It is important to check the Velcro strips on a weekly basis for wear and replace when
appropriate in order to prevent potential false alarms.
Bosch Security Systems, Inc
Separate the Velcro strips from one another.
Peel off the protective backing of the Velcro strips.
Press the two bottom sections of the Velcro onto the bottom of the cash drawer, in the
desired location.
Line up and press down on the bill trap so that the Velcro on the bottom of the bill trap is
aligned with the Velcro strips inside the cash drawer.
Reference Guide
RADION specialty | en
41
02.2014 | 01 | F.01U.261.835
Advertisement
Table of Contents
