Power Source - Toshiba 15LV505 Owner's Manual

nnecting to optional equipment (Continued)/
Power source
Connecting to an amplifier equipped with a digital audio input
I
To COAXIAL DIGITAL
AUDIO OUT
75
Q
coaxial cable (not supplied)
Amplifier equipped with a
Digital audio input
To COAXIAL
type digital
audio input
2 channel digital stereo
You can enjoy the dynamic sound of 2 channel digital stereo by connecting an amplifier equipped with a digital audio input and speaker
system (right and left front speakers).
Note:
PCM audio is limited to DVD or CD playback.
Back side
Note:
DO NOT connect the COAXIAL DIGITAL AUDIO OUT jack of the TV/DVD to the AC-3 RF input of a Dolby Digital Receiver.
This input on your
AN
Receiver is reserved for Laserdisc use only and is incompatible with the COAXIAL DIGITAL AUDIO OUT jack
of the TV/DVD.
Connect the COAXIAL DIGITAL AUDIO OUT jack of the TV/DVD to the "COAXIAL" input of a Receiver or Processor.
Refer to the owner's manual of the connected equipment as well.
When you connect the TV/DVD to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet
before making any connections.
The output sound of the TV/DVD has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening level.
Otherwise, the speakers and your hearing may be damaged by a sudden high volume sound.
Turn off the amplifier before you connect or disconnect the TV/DVD's power cord. If you leave the amplifier's power on, the speakers
may be damaged.
[ Power source
To use AC power source
1. Open the AC INPUT cover.
2. Connect the AC cord plug into this TV/DVD's AC INPUT jack, then close the AC INPUT cover.
3. Connect the AC cord into an AC outlet.
, u'
b
---"'
...
'
.
...
' " 0
AC 120V, 60Hz
---===~
AC Outlet
Wider Hole
and Blade
Note:
• Never connect the AC line cord plug to other than the specified voltage (120V 60Hz). Use the attached power cord only.
• If the polarized AC cord does not fit into a non-polarized AC outlet, do not attempt to file or cut the blade. It is the user's
responsibility to have an electrician replace the obsolete outlet.
• If you cause a static discharge when touching the unit and the unit fails to function, simply unplug the unit from the AC outlet
and plug it back in. The unit should return to normal operation.
• If the AC cord plug is plugged in for the first time, wait for approx. 5 seconds before pressing
POWER.