Toshiba 15LV505 Owner's Manual page 43

.--~~-
EJECT
• •n . ( •
~ POWER
• To obtain a higher quality picture
Occasionally, some picture noise may appear on the TV screen while playing a
DVD video disc because the high resolution pictures on these discs include a
lot of information. In such case, you may reduce the Sharpness with the Picture
Setting menu
~.
• About
(@>C@>CID
The (@>c@>CID icons on the heading bar show the playable discs for the
function described under that heading.
(@> : You can use this function with DVD video discs.
~
: You can use this function with Video CDs.
CID : You can use this function with Audio CDs and CD-R/RW CDs.
" T ' ....
PLAY
..~STOP
c") c='
0 :..
J
PAUSE
[
~
Basic playback (continued)
• To stop playback
Press STOP.
STOP
CI)
•
~EJECT
Remove the disc after the disc comes
out.
o
• To remove the disc
Press EJECT.
• The sound is muted during still
mode.
PLAY
~
• To pause playback (still mode)
Press PAUSE during playback.
PAUSE To resume normal playback,
CJI)
press PLAY.
Note:
If a non-compatible disc is loaded, "Incorrect Disc", "Region Code Error" or "Parental Error" will appear on the TV screen
according to the type of loaded disc. In this case, check your disc again
[I)~.
Some discs may take a minute or so to start playback.
When you set a single-faced disc label downwards (ie. the wrong way up), "Reading" will appear on the display for a few
minutes and then "Incorrect Disc" will continue to be displayed.
Some discs may not work the resuming facility.
Resuming cannot function when you playa PSC-featured Video CD while the PSC is on. To turn off the PSC
IE>.
Some playback operations of DVDs may be intentionally fixed by software producers. Since this unit plays DVDs according
to the disc contents the software producers designed, some playback features may not be available. Also refer to the
instructions supplied with the DVDs.
Do not move the unit during playback. Doing so may damage the disc.
Use the EJECT to unload and eject the disc.
Do not put any objects other than discs on the disc slot. Doing so may cause the unit to malfunctions.
In many instances, a menu screen will appear after playback of a movie is completed. Prolonged display of an on-screen
menu may damage your television set, permanently etching that image onto its screen. To avoid this, be sure to press
POWER on the remote control once the movie is completed.
There may be a slight delay between the button is pressed and the function activates.
43
1