Back Panel Switches - AMT Datasouth Fastmark 6000 Series User Manual

Back Panel Switches

Any change in switch position is not registered until Power is cycled.
Standard Switch Settings
Switch Function
Number
1 Thermal
Transfer
Ribbon
2 Standard
Control
Codes
3 Cutter
4 Gap Size
5
44 User's Guide
Position Description
setting
ON Ribbon is installed. Thermal transfer mode. Enables
end-of-ribbon detection. If end-of-ribbon occurs the
RIBBON and READY indicators will blink.
OFF Ribbon is not installed. Direct thermal.
ON Alternate control code set is printable
OFF Standard control code set.
ON Cutter is installed.
OFF Cutter is not installed.
ON The gap length is more than 4 mm.
OFF Media with normal gap or continuous media.
ON Peeler is installed.
OFF Peeler is not installed.
Fastmark 6000 Series