Advertisement
4
Using Your Remote Transmitter
Press to Lock Doors
Locking the Vehicle Doors
To lock the doors press
*
the LOCK button. The horn** will "honk" and
the parking lights will flash, indicating the system has locked the
doors.
Unlocking the Vehicle Driver's Door
To unlock only the vehicle driver's door (if this option is selected),
press the UNLOCK button, once. The horn will "honk" and the parking
lights will flash, indicating the system has unlocked the door. If this
option is selected, the courtesy light will turn on for 1 minute.
Unlocking All Doors Using Second-Stage Door Unlock
To unlock all doors , press UNLOCK twice within 1 minute.
Activating the Trunk Release Feature
Press and hold TRUNK to open the vehicle trunk or hatch (if equipped
and connected). If this button is used to operate another accessory,
the accessory will stay active for as long as the button is held.
Personal Protection Alarm (Panic)
Press and hold both buttons to activate the vehicle horn and parking
lights for 30 seconds. Press any remote control button to turn off the
Panic alarm.
* Throughout this manual, 'press' refers to pressing for less than 1 second; 'press and hold' refers to
pressing for more than 1 second.
** If you have chosen the Silent Arming Option, the horn will not sound when Locking or Unlocking
the doors until the corresponding button is pressed a second time.
Programming Your Remote Transmitter
Note: Each system module has four "slots", or memory locations, to
store transmitter codes, giving it the ability to operate from up to
four transmitters. For proper operation, a transmitter code must be
Press to Unlock Door
stored into each memory slot. When using less than four
Press TWICE for
transmitters, follow the suggested programming parameters:
Second Stage Door
Unlock
*
Press and HOLD for
Trunk
*
Press BOTH Buttons
1. Open the driver's door.
for Panic
2. Turn vehicle ignition on.
3. Press and hold emergency override button.
After 10 seconds, the siren or horn will sound three (3) times. This
indicates that the unit has entered the transmitter programming mode.
4. Release the button.
5. Press the LOCK button on the remote transmitter to be
programmed.
The siren or horn will sound once, indicating that the system has
"learned" that remote transmitter.
6. Repeat step 5 for any additional transmitters or transmitter codes.
7. To continue to the Options Programming mode, go to
Programming Selectable Options (below). Otherwise, turn the
vehicle ignition off to exit the programming mode. Test all remote
transmitters to ensure that they work properly by toggling the
LOCK and UNLOCK buttons. Do not press the START button until
programming the tach signal (page 12).
Programming Selectable Options
Note: Transmitters must be programmed prior to these steps.
1. Repeat steps 1-4 of Remote Transmitter Programming (above).
2. Press and release the emergency override button.
The horn or siren will sound four (4) times. This indicates that the
unit has entered the Keyless Options Programming mode.
3. Press the PANIC button to advance to the next feature.
The siren or horn will sound a number of times to indicate the
number of the option.
• One Remote Transmitter - Program four (4) times
• Two Remote Transmitters - Program each transmitter two
(2) times
• Three Remote Transmitters - Program two transmitters
one (1) time, and the remaining transmitter twice.
9
Advertisement
