Advertisement
4
Using Your OEM Remote Control Transmitter
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press* the
LOCK button on your OEM Keyless Entry Remote Control. The horn
†
will "chirp" twice
and the parking lights will flash twice, indicating the
system is armed. The status indicator (red warning light on the dash)
will blink steadily, once per second.
Pre-arm Mode
If the horn chirps and the parking lights flash only once, this indicates
that the vehicle courtesy light is on, or that an entrance is not closed
securely. Check to see that doors, hood, and trunk are properly
closed. Once all entrances are secured (and the courtesy light is off),
the system will chirp / flash again. The system is now fully armed. (If
the entrance is not secured within 4 minutes, the system will arm
and ignore the unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system, press the UNLOCK button on your OEM
Keyless Entry Remote Control. The siren will chirp and the parking
lights will flash once.
Attempted Intrusion Identification
If the horn chirps four times when disarming, this indicates that the
system was triggered in your absence. The status indicator will also
flash rapidly. Perform the following
operation to determine the protected
zone that triggered the system:
After disarming, press the
emergency override button.
The horn/siren will chirp to indicate
the cause of the alarm trigger:
When Your Security System is Triggered
The CA-330 will trigger if one of the following events occurs while the
system is armed:
• Any protected entrance is opened
• The vehicle ignition is turned on
• The vehicle is jolted hard enough to signal the impact detector
Once the alarm is triggered, the siren (or horn) sounds and the
vehicle parking lights flash for 30 seconds. The system will then re-
arm, awaiting the next intrusion attempt. To stop the siren while
keeping the alarm armed and doors locked: press the LOCK button
(on the OEM Keyless Entry Remote) while the system is triggered.
* Throughout this manual, 'press' refers to pressing for less than 1 second; 'press and hold' refers to
pressing for more than 1 second.
** 'Siren' also refers to the vehicle horn if it is used as the alarm sounding device.*
†
If you have chosen the Silent Arming Option, the siren will not sound when arming or disarming until the
appropriate button is pressed a second time.
CA 330 owners rev 7-04.pmd
1 chirp IT-s Interior Theft Sensor
2 chirps Door
3 chirps Hood
4 chirps Trunk/Optional Sensors
5 chirps Ignition was turned on
4
8/12/2004, 12:26 AM
Advertisement
