Table of Contents
Advertisement
8 SpeedMill
ASSEMBLY AND OPERATION
Mount the SpeedMill Bowl
Assembly. Align the slot in the
SpeedMill Hub with the face of
the shaft. Make sure the flange
face of the SpeedMill Hub con-
tacts the face of the blade.
Install the blade shaft bolt into
the Hub Assembly.
Using Combination Spanner,
Supplied with machine, tighten
blade shaft bolt by turning it
clockwise. Torque to 130-215
in-lbs. (15-25 Nm).
Before using the assem-
bled machine, completely
read the power cutter op-
eration manual supplied
with this machine.
OPERATION:
Before starting up machine make sure you
completely read these instructions and the
power cutter operation manual. Be familiar with
operation of the machine before operation!
EVACUATE PIPE CONTENTS before cutting; else
EXPLOSION may occur! Static electricity from cut-
ting operation may cause gas or other pipe contents
to explode (for installed piping).
Position plastic pipe so pipe end is
off the ground. Secure pipe in place
if required. Example: Set plastic
pipe between two of the boards of a
wooden pallet.
Start machine per instructions in K750
Power Cutter Operation Manual.
WARNING!
WARNING!
Before starting machine,
verify that when SpeedMill
Bowl and blade is positioned
to cut / bevel the plastic pipe,
that it clears all objects in the
cutting area.
Position machine at top of plas-
tic pipe to begin cutting through
the pipe wall.
Move saw forward while
maintaining a "square cut"
on the end of the pipe. This
means the cut should al-
ways be perpendicular to the
length of the pipe.
Advertisement
Table of Contents
