Power Trigger And Power Trigger Lockout; Wiring Assembly - Husqvarna K 1 PACE Workshop Manual

8.3 Power trigger and power trigger lockout

8.3.1 To remove and install the power trigger and
the power trigger lockout
1. Remove the left handle half. Refer to
disassemble and assemble the handle half on page
24 .
2. Remove the power trigger lockout.
3. Remove the power trigger.
4. Install in the opposite sequence.
Note: Make sure that the microswitch lever on the
control panel is above the power trigger.
26 - Repair instructions
To

8.4 Wiring assembly

8.4.1 To remove and install the wiring assembly
1. Remove the left handle half.
2. Remove the control unit. Refer to
install the control unit on page 25 .
3. Remove the power trigger and power trigger lockout.
Refer to
the power trigger lockout on page 26 .
4. Remove the wiring assembly.
5. Push the locking clip and remove the control panel.
To remove and install the power trigger and
1597 - 003 - 05.07.2023
To remove and