Assembly - Husqvarna K 540i Operator's Manual

• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
®
Bluetooth
CAUTION:
made to this equipment not expressly
Cutting blades
WARNING:
gloves when you assemble the product.
WARNING:
and cause injury to the operator.
WARNING:
for cracks, lost segments distortion or
unbalance prior to use and immediately after
striking an unintended object. Do not use a
damaged cutting blade. After inspecting and
installing the cutting blade, position yourself
and bystanders away from the plane of the
rotating cutting blade and run the power tool
at maximum no load speed for one minute.
WARNING:
manufacturer gives warnings and
recommendations for the operation and
correct maintenance of the cutting blade.
Those warnings are supplied with the cutting
blade. Read and obey the instructions that
are supplied with the cutting blade.
Cutting blade vibration
CAUTION:
with too much force, the cutting blade
can become too hot, bend and cause
vibrations. Use the product with less force.
1960 - 002 - 25.08.2023
Changes or modifications

Assembly

Always use protective
A cutting blade can break
Examine the cutting blade
The cutting blade
If you use the product
approved by Husqvarna may void the FCC
authorization to operate this equipment.
Notice: This device complies with Part 15 of FCC
Rules and with Industry Canada licence-exempt RSS
standard. Operation is subject to the following two
conditions:
• This device may not cause harmful interference
• This device must accept any interference received,
including interference that cause undesired
operation.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes:
• l'appareil ne doit pas produire de brouillage, et
• l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
If the vibrations continue, replace the cutting
blade.
Applicable cutting blades
CAUTION:
recommended cutting blades for K 540i and
the material to be cut. The recommended
cutting blades decrease the risk of serious
injury and increase the cutting and X-halt
performance. If general high speed cutting
blades are used, the performance and
cutting quality will decrease.
WARNING:
and abrasive blades for concrete and metal.
Do not use blades with serrations such
as circular wood cutting blades or blades
with carbide tips. The risk of kickback is
increased and carbide tips can come off and
be thrown at high speed. This can result in
injury or death.
WARNING:
for any other materials than what it was
intended to cut.
WARNING:
that comply with applicable national or
regional standards, for example EN12413,
ANSI B7.1. or EN13236.
Use Husqvarna
Only use diamond blades
Never use a cutting blade
Use only cutting blades
13