HOLD MACHINE ONLY at front and rear handles!
NEVER bevel or cut material while holding the pipe with
your hands!
DO NOT use blade guard pivot handle as a hand hold
while operating machine!
HOLD MACHINE ONLY at front and rear handles, as shown in
the above photo.
Rotate Pipe and repeat this cut-
ting process until pipe circum-
ference is cut.
Bevel Pipe: Position SpeedMill
Bowl near end of pipe to be
beveled. Accelerate power cut-
ter to full throttle.
WARNING!
OPERATION
Align proper SpeedMill Bowl
with end of pipe, and move
toward the pipe so that the pipe
is slightly beveled.
Note: The bevel required is
usually quite small, so do not
remove excessive pipe mate-
rial.
SpeedMill 9