Assembly; Operation - Husqvarna 130 Mark II Operator's Manual

• During transportation or storage of the product, use
a transportation guard or case to move the product.
WARNING:
safety chapter before you assemble the
product.
To assemble the guide bar and saw
chain
1. Remove the bar nuts and the clutch cover. Remove
the transportation guard (A). (Fig. 35)
2. Put the guide bar above the bar bolts. Steer the
guide bar to its most rear position.
3. Put on protective gloves.
4. Lift the saw chain above the drive sprocket and
engage it in the groove on the guide bar. Start on
the top edge of the guide bar. (Fig. 36)
5. Make sure that the edges of the cutters are turned
forward on the top edge of the guide bar.
6. Assemble the clutch cover and steer the chain
adjuster pin to the hole in the guide bar.
WARNING:
safety chapter before you operate the
product.
To use fuel
CAUTION:
cycle engine. Use a mixture of gasoline
and two-cycle engine oil. Make sure to use
the correct quantity of oil in the mixture.
Incorrect ratio of gasoline and oil can cause
damage to the engine.
Fuel mixture ratio
The fuel mixture ratio for the gasoline and two-cycle
engine oil is 50:1 (2%)
Gasoline
1 U.S. Gal.
1 UK Gal.
5 l
862 - 003 - 09.07.2022

Assembly

Read and understand the

Operation

Read and understand the
This product has a two-
Two-cycle engine oil
77 ml (2.6 oz)
95 ml (3.2 oz)
100 ml (3.4 oz)
• Do not use waste oil. Waste oil can be dangerous
to you and can cause damage to the product and
environment.
7. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket. Also make sure that
the saw chain is correctly engaged in the groove in
the guide bar.
8. Tighten the guide bar nuts finger.
9. Turn the chain tensioning screw clockwise to tighten
the saw chain. Tighten the saw chain until it does not
hang from below the guide bar, but you can turn it
easily by hand. (Fig. 37) (Fig. 38)
10. Hold up the end of the guide bar and tighten the bar
nuts with the combination wrench. (Fig. 39)
• Examine the chain tension frequently after you
assemble a new saw chain and until the saw
chain has been run-in.
• Examine the chain tension regularly. Correct
chain tension results in good performance and
a long life.
To make the fuel mixture
1. Determine the correct quantity of gasoline and
engine oil (mixture ratio 50:1). Do not make more
than 30 days quantity of fuel mixture. See
mixture ratio on page 15 .
2. Add half of the gasoline quantity to a clean fuel
container with an antispill valve.
CAUTION:
more than 10% ethanol concentration
(E10). This can cause damage to the
product.
CAUTION:
an octane number less than 90 RON
(87 AKI). This can cause damage to the
product.
Note:
Use gasoline with a higher octane number if
you frequently use the product at continuously high
engine speed.
3. Add the full quantity of the two-cycle engine oil to the
fuel container.
Fuel
Do not use gasoline with
Do not use gasoline with
15