Table of Contents
Advertisement
Safety Instructions
General Instructions
This workshop manual has been written for users who have a good understanding of the repair and
servicing of ride-on mowers.
The workshop where the ride-on mower is repaired must have have all the safety systems demanded by
local regulations.
No one is to attempt to repair the ride-on mower without having first read and understood the contents of
this manual.
The ride-on mower has been safety tested. Safety approval applies only when the ride on-mower uses
parts or equipment supplied or recommended by Husqvarna Turf Care.
Special Instructions
The fuel used in the ride-on mower is hazardous if used incorrectly. Pay particular attention to the following:
•
The fuel and the fumes it gives off are toxic.
•
Eye and skin complaints can result from incorrect exposure.
•
Breathing difficulties can result from incorrect exposure.
•
The fuel and fumes are highly flammable.
When using compressed air, users must not direct the air stream towards themselves or any other person.
Air may penetrate the blood stream and cause life-threatening damage.
Use hearing protectors when test driving.
After test driving, do not touch the muffler before it has cooled down (danger of burns). This especially
applies if the ride-on mower has a catalytic converter. If consumed, the lining on and in the catalytic
converter element can damage health. Wear protective gloves whenever working on the catalytic converter
or the silencer.
With the engine running, many engine and drive system components become hot and may cause burns if
touched. Do not touch such components before they have cooled down.
When draining oil from a hot engine or hot hydraulic system, be aware that the oil can be hot enough to
cause burns. Wear protective glasses whenever there is a risk of splashing.
The mower blades are sharp. To avoid cuts, always wear protective gloves when handling the blades.
Wear protective glasses when working with springs. Springs can detach from their mounts and fly with
great force into unprotected eyes.
Use the right tools for each job. Check all tools before using them and repair or replace as necessary.
SAFETY INSTRUCTIONS
3
English-
Advertisement
Table of Contents
Troubleshooting
