Husqvarna ZTH5223 Workshop Manual page 24

The oil level must be between the
markings on the dipstick. If the level is
near the "ADD" mark, top up with oil to
the "FULL" mark.
Oil is topped up via the hole in which the
dipstick sits.
Use grade SC-SH engine oil with a
viscosity as per the chart below.
The engine (excluding oil filter) holds 1.5
litres of oil.
10. Check the oil level in the hydraulic tank.
The level must be 19 - 25 mm below the
top of the tank. Top up if necessary.
11. Adjust the motion control levers.
a. Set the seat longitudinally in a
comfortable position and swing the levers
into the drive channel.
b. Hold one of the levers at a comfortable
midpoint and tighten the retaining bolts.
c. Hold the other lever as far forward as the
first and tighten the bolts.
22
English-
DELIVERY SERVICING
ADD
ADD
FULL
Engine dipstick
-20 C -10 C 0 C
SAE10W-30/SAE10W-40
SAE5W-20
-4 F 14 F 32 F
Viscosity chart
Hydraulic tank
Adjusting the motion control levers
FULL
8009-159
10 C 20 C 30 C 40 C
SAE40
SAE30
50 F 68 F 86 F 104 F
8009-140
8011-565
8011-522