Checking And Adjusting The Choke Wire - Husqvarna ZTH5223 Workshop Manual

the diagram.
3. Pull the throttle wire casing to the far
right and tighten the clamping screw.
Checking and Adjusting the Choke
Wire
If the engine produces black smoke or is
difficult to start, the choke wire (upper wire)
may be incorrectly adjusted.
To adjust the choke, proceed as follows:
1. Release the clamping screw that secures
the wire casing and set the choke control
to maximum choke.
2. Check that the throttle wire is attached to
the upper lever, see the diagram.
3. Pull the choke wire casing to the far right
and tighten the clamping screw.
32
English-
REPAIRS

Checking and adjusting the choke wire

8011-555