Log Placement - Napoleon GVFS60N Installation And Operating Instructions Manual

12
4.2

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER
logs glow when exposed to direct fl ame and provide a unique and realistic glowing effect. Use only certifi ed
TM
PHAZER logs available from your local authorized
dealer / distributor.
A. Place log #1 onto the burner, centering it onto
the burner tray and pushing it as close to the rear
wall of the fi rebox as possible. Move logs #2 and
#3 into position, lining up the studs located on the
burner with the holes on the bottom of the logs.
Sit the notch at the bottom of log #4 against the
left outermost grate post and position the top of
the log into the pocket provided on the rear log
(#1).
B. The notch in log #5 should be pressed down onto
the skewering pin located at the end of the grate
as shown to prevent it from rocking.
C. Position the notch located in log #6 against the
grate post and rest it within the notch in log #4.
D. Place the bottom of log #7 against the right
outermost grate post and the top into the pocket
provided on the center log (#6). Bend up the
tab in the log support to cradle log #7. Tear the
glowing embers into pieces and place onto the
front of the burner. Care should be taken to shred
the embers into thin, small irregular pieces as
only the exposed edges of the fi bre hairs will
glow when exposed to direct fl ame; however
care should be taken to not block the burner
ports. Blocked ports can cause an incorrect fl ame
pattern, carbon deposits and delayed ignition.
Replacement loose material must be purchased from the
original room appliance manufacturer. Application of ex-
cess loose material may adversely affect the performance
of the appliance.
Log colours may vary. During the initial use of the appli-
ance, the colours will become more uniform as colour pig-
ments burn in during the heat activated curing process.
POSITIONING THE LOGS IMPROPERLY WILL CAUSE
FLAME IMPINGEMENT AND CARBONING.
W415-0796 / C / 03.19.12
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
WARNING
!
76.1A
1
4
2
5
6
TM
3
7