Engine Adjustments; Starting The Engine - Husqvarna Royal 153 S Operator's Manual

A A A A A
1 Upper handles
2 Fuel-enrichment pump
3 Fastening knobs for upper handles
4 Grass catcher
5 Oil filler cap
6 Oil drain plug
B B B B B
C C C C C
D D D D D
E E E E E
F F F F F
To cut the grass with the mulching system (no grass collection), lift the rear deflector panel and insert the cap by fixing it with the spring as shown in the figure.
G G G G G
H H H H H
I I I I I
l Always operate with the deflector or grasscatcher in the correct position.
l Always stop the engine before removing the grasscatcher or adjusting the height of cut.
l Never place your hands or feet underneath the deck or into the rear grass discharge chute while the engine is running.
J J J J J
Before mowing, remove all foreign objects from the lawn which may be thrown by the machine. While mowing, stay alert for any foreign objects which may have been
missed.
Never lift the rear of the mower while starting the engine or during normal operation.
K K K K K
Never place your hands or feet underneath the deck or into the rear discharge chute while the engine is running.
L L L L L

ENGINE ADJUSTMENTS

Refer to the engine manufacturer's maintenance manual.
CAUTION:- 0.6l Oil must be added to the engine before use.
M
M M M M M

STARTING THE ENGINE

Once the machine has been set up properly, start the engine as follows:
a) Engines with choke system:
when the engine is cold, position the accelerator lever (13) on START
b)Operate the engine stop lever (14) to prepare the engine for start, keep lever pressed against handle while starting and using the machine - it operates the engine brake.
c) Engines with primer system:
Press the fuel-enrichment pump (2) located on the carburettor 3 or 4 times position the accelerator lever (13) on MAX.
For further information and explanations, read carefully the user instruction manual of the engine.
N N N N N
d) Start engine.
MANUAL STARTING: (While holding the engine stop lever (14)).
lHold the engine start-grip (11) and pull the starter rope gently until you feel the resistance caused by compression. Return the starter rope slowly then pull the handle
firmly towards you to its full extent.
7 Deck
8 Adjusting levers for cutting height
9 Spark plug
10 Fuel cap
11 Engine start-grip
12 Rear deflector
13 Throttle lever

Self-Propelled Lawnmower.
Remove the bail arms, attach cables as shown and re-fit the bail arms.
3 Speed Self-Propelled Lawnmower.
Remove the bail arms, attach cables as shown and re-fit the bail arms.
3 Speed Self-Propelled Lawnmower with Blade Brake.
Remove the bail arms, attach cables as shown and re-fit the bail arms.
9
14 Engine stop lever
15 Reduction gear
16 Console
17 Ignition key
18 Clutch lever
19 Blade engagement lever
20 Handle advance speed
ENGLAND