Table of Contents
Advertisement
ened. Clean the element with a high pressure garden hose. Every other
cleaning, soak the element in a filter cleaning solution, then rinse it
thoroughly, and reinstall. Replace the skimmer basket assembly and the
access lid or cover. After cleaning, run the pump for a few minutes at
high speed, then return to the heating mode.
To clean the Ultra Pure filter element for those spas with Ultra Pure,
remove the skimmer access lid and pull up on the Ultra Pure filter
flange. Next, pull the filter element out by twisting the molded handle
until the filter is loosened. Clean the element with a high pressure gar-
den hose. Every other cleaning, soak the element in a filter cleaning
solution, then rinse it thoroughly, and reinstall. Replace the access lid or
cover.
L I G H T B U LB R E P LAC E M E N T
All spas are equipped with a 12 volt light using a GE912 bulb. To
change the bulb, turn the power off and drain the spa below the level of
the spa light. Using the special tool provided in the owner's manual
packet, unscrew the cover for the light housing. Remove the old bulb
and install the new bulb. Screw the cover for the light housing back
into the female receptacle. Check to ensure proper operation of the new
bulb before refilling the spa.
NOTE:
1) Do not attempt to remove the light housing cover without the special
tool. If you are not able to locate it, contact the Dimension One
Spas Service Department to have one sent.
2) Be sure the O-ring is not damaged and is properly in place when
replacing the lens. Contact Dimension One Spas if a replacement
O-ring is needed.
CA R E F O R T H E S P A S U R F AC E - U L T R AL I F E
Your UltraLife spa has a very high quality finish. Stains and dirt will
generally not adhere to the surface. Cleaning of the surface should be
done with baking soda or Soft Scrub. Be careful when using detergents
not to leave soap residue on the spa shell as this will cause suds build up
1999 Owner's Manual
43
Hide quick links:
Advertisement
Table of Contents
