Programming The Programmable Digital Control - Dimension One Spas Chairman II Owner's Manual

21
1999 Owner's Manual
NOTE: Pushing the JETS pad will disable any concurrent filter cycle.
T E M P E R A T U R E P A D S
Pushing the UP pad increases the temperature and pushing the DOWN
pad decreases the temperature. Push the respective pad one time for
each degree of temperature change, or push and hold the pad for rapid
adjustment. The existing spa water temperature will remain in the digi-
tal display window until a temperature pad is pushed. When the UP or
DOWN pad is pushed the digital readout will indicate the new tempera-
ture setting, with the SET POINT Icon on the right side of the display.
Once the new temperature is set, the current spa water temperature will
again be indicated. The spa will heat to the pre-set temperature auto-
matically.
L I G H T
Push the LIGHT control pad once to activate the brightest setting. A
second push will activate the medium setting and a third push will acti-
vate the dimmest setting. The light icon and LED on the display will
come on when the light is activated. Push the LIGHT control pad a
fourth time to turn off the light. The light will automatically turn off
after 4 hours of continuous operation.
PROGRAMMING THE PROGRAMMABLE
DIGITAL CONTROL
To initiate the programming sequence at any time, push and hold the
PROGRAM pad for 3 seconds. If, within 10 seconds, you do not pro-
ceed with the spa programming, the spa will automatically exit the pro-
gramming sequence and revert to the pre-set factory default settings. To
exit the programming sequence at any time, do not press any pad for 10
seconds. Any programming changes made up to that point will be saved.
CL O CK S E T
Push and hold the PROGRAM pad for 3 seconds to engage the time set-
ting mode. The time screen will appear with "hours" (_ _.00) flashing