Epson TM-T88V-DT User Manual page 11

1. Pass the interface cables through the wire saddle on the pole mounting plate.
2. Pass each cable through the cable exits at the bottom of the connector cover.
3. If you use the product with the optional customer display, remove the U-
shaped part from the connector cover as shown in the illustration blow. If you
use the product without the optional customer display, keep the U-shaped
part attached.
4. Align the tabs on the upper side of the connector cover with the notches on
the main body, and push the front part of it to click onto the printer cover.
5. Hold the lower part of the connector cover, align the tabs on the upper side of
it with the notches on the main body as shown in the illustration below, and
push the front part of connector cover to attach it.
6. Turn over the main body back on its bottom, and make sure the cables are not
pinched.
Wire saddle
TM-T88V-DT User's Manual 11
English