Usb Wake-Up - Supermicro Super X7SPA-L User Manual

USB Wake-Up

Use JPUSB jumpers to enable the func-
tion of "System Waking-Up via USB
devices". These jumpers allow you to
"wake-up" the system by pressing a key
on the USB keyboard or by clicking the
USB mouse of your system. The JPUSB
jumpers are used together with the USB
Wake-Up function in the BIOS. Enable
both the jumpers and the BIOS setting
to enable this function. See the table on
the right for jumper settings and jumper
connections. (Note: JPUSB1 is for Back
Panel USB ports:0/1, and JPUSB2 is for
Front Panel USB ports:2/3,4/5.)
(Note: The default jumper setting for the
USB ports is "Disabled". When the "USB
Wake-Up" function is enabled in the BIOS
and the selected USB ports are also
enabled via the JPUSB jumpers, please
be sure to remove all other USB devices
from the USB ports whose USB jumpers
are set to "Disabled" before the system
goes into the standby mode.)
KB/MOUSE
COM1
J10 J11
JVGA1
LAN1
LAN2
AUDIO FP
CD-in
JSMB1:SMBus1
JSMB1
FAN1 FAN2
SYS FAN
J13
JPC3
J12
JPL1
JI2C1
JPL2 JL1 JPG1
SLOT1 PCI-E X4 (IN X16 SLOT) X7SPA-L
JPCIE1
JI2C1 ON:ENABLE
OFF:DISABLE
2-25
Chapter 2: Installation
USB Wake-Up
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
USB Wake-up
A
JLPC80
JBT1:
COMS CLEAR
I-SATA2
T-SGPIO2 T-SGPIO1 J2
JI2C2 ON:ENABLE
+
OFF:DISABLE
SP1
I-SATA5
JBAT1
JBMC1
REV:1.00
Definition
Enabled
Disabled (Default)
JPW1
JPI2C1
I-SATA1 I-SATA0
I-SATA4 I-SATA3
A
D17
J8
JPUSB1
JOH1
JUSB4
JUSB3