Watch Dog Timer Enable; Usb Wake-Up - Supermicro X10SDV User Manual

Watch Dog Timer Enable

Watch Dog (JWD1) is a system monitor that
can reboot a system when a software applica-
tion hangs. Close pins 1-2 to reset the sys-
tem if an application hangs. Close pins 2-3 to
generate a non-maskable interrupt signal for
the application that hangs. See the table on
the right for jumper settings. Watch Dog must
also be enabled in the BIOS Setup. The de-
fault timer is around 5 minutes.

USB Wake-Up

Use the JPUSB1 jumper to enable the
function of "System Waking-Up via USB
devices" for USB0/1. This jumper allows
you to "wake-up" the system by pressing
a key on the USB keyboard or by click-
ing the USB mouse of your system. The
JPUSB1 jumper is used together with
the USB Wake-Up function in the BIOS.
Enable both the jumper and the BIOS
setting to enable this function. See the
table on the right for jumper settings and
connections.
A
C
JNVI2C1
SLOT7
PCI-E 3.0 X16
A
B
VGA
SRW2
LAN3/4
LED8
C
SRW1
X10SDV-F
REV: 2.00
DESIGNED IN USA
BMC
AST2400
C
LEDM1
A J21
Intel
D-1500
USB 4/5
LED3
A JF1 I-SGPIO1
C I-SGPIO2
JPME1
2-29
Pin#
1-2
2-3
Open
Pin#
1-2
2-3
A. Watch Dog Enable
B. USB Wake-Up
JPL1
i350
USB 0/1(3.0)
LAN1/2
IPMI_LAN
BT1
JBT1
J6
FAN2
JF1:
OH HDD PWR
PWR
RST X NIC2 NIC1
LED
ON FF LED
Chapter 2: Installation
Watch Dog
Jumper Settings
Definition
Reset (Default)
NMI
Disabled
USB Wake-up
Jumper Settings
Definition
Enabled (Default)
Disabled
COM1
USB 2/3
JPI2C1
PJ1
JPW1
FAN1