Control Arms; Seat Install; Engine Oil; Adjustments - Husqvarna BZ6127TD/968999262 Operator's Manual

Control Arms

Remove top bolt in control arm and loosen bot-
tom bolt, rotate the control levers to the upright
position. Align the levers so they are even in the
neutral position. Reinstall hardware and tighten.
FIG - 1
Wire Harness
1. Connect the wire harness from the seat to the
frame harness.

Engine Oil

Check engine oil with dip stick. Add if needed per
the engine manufactures specifications. See en-
gine manual for oil type and filling specifications.
FIG - 2
Loosen the discharge chute slightly and lower into
position. Chute should be snug but still pivot freely.

Adjustments

Cutting Height
Stop the mower and disengage the blades.
Raise the deck height lever to the transport posi-
tion.
Remove the height adjustment pin and place it in
the desired cutting height hole. Lower the lift lever
down onto pin. NOTE: Anti-scalp rollers must be
in the proper position for maximum deck floata-
tion. See the decal on the front deck for proper
settings. FIG - 3
16
SETUP AND ADJUSTMENTS
Control
Arm
FIG - 1
Operating
Range
FIG - 2
Deck Height
Adjusment Plates
FIG - 3
Motion
Control
Lever
"F" Full
Mark
Lift Lever