Replacing The Air Filter - Husqvarna BZ6127TD/968999262 Operator's Manual

Replacing the Air Filter

If the engine seems weak or runs unevenly and
the dust load indicator has turned red the air filter
may be clogged. If run with a clogged air filter,
disruption of operation can occur.
Cleaning/replacing the air filter is carried out as
follows
Only do so when the dust indicator is red.
WARNING!
Allow the exhaust system to cool
before performing service. Risk
for burns.
1. Unfasten the two plastic clamps on the sides
of the air filter cover. Remove the air filter cover.
2. Remove the paper filter. Lightly brush or use
mild air pressure to clean
IMPORTANT INFORMATION
Do not use compressed air to clean the air
filter.
Do not washt the paper filter.
Do not oil the paper filter. Do not tap filter
to clean this could cause damage to the
sealing.
3. Only remove and replace safety element after
the paper filter has been replaced 3 or 4 times.
4. Refit the air filter as follows:
Check that the seal on the bottom of the paper
filter is whole.
Mount the safety element in the air filter
housing.
5. Place the paper filter over the safety element.
6. Replace the cover over the air filter housing.
Fasten the two plastic clamps making sure the
cover is snapped into position.
7. Push top of dust load indicator to reset it.
38
MAINTENANCE
DUST LOAD
INDICATOR
Remove the air filter cover
Paper filter
Safety element
CLAMP
CLAMP
BAM-15
BAM-16
BAM-17