Displaying Waveform - Toshiba RSM 100 Instruction Manual

1.1

Displaying Waveform

This section describes displaying the waveforms.

■Displaying Waveform

■Opening Waveform Data
■Displaying Version Information
■Displaying Waveform
The software allows you to analyze waveforms from the instantaneous value data of voltage
and current recorded by protective relays when faults or disturbances occur in power systems.
This part describes displaying waveforms when they are opened in the PC control software.
《Operating Procedure》
① Opening a waveform data in the PC control software displays the fault time
1-2
information and the waveforms.
･ 3 cursors are displayed at the following points in the channel in which the voltage drop ratio is the largest.
Fault detection point
Lowest voltage point
Restoration from fault point
･ You can previously select whether the fault time is calculated automatically when a waveform data is
displayed.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Options)
■Closing Waveform Display
Cursor 0 (Green)
Cursor 1 (Red)
Cursor 2 (Yellow)
⎯ 78 ⎯
6 F 2 S 0 7 1 5
Vertical
scroll bar
Horizontal scroll bar