Selecting Options - Toshiba RSM 100 Instruction Manual

■Selecting Options

This part describes how to select the options.
《Note for Operation》
● The following selections are available.
● The option selections are common to all the waveform data.
《Operating Procedure》
① On the [Set] menu, click [Option].
② Select an option that you want to select for each item.
③ Click【OK】button.
･ The selected options are set.
2-6
・Hard Copy Mode
・Phase
・Unit at Start
・Value
・Fault Section Calculation
Note: When no voltage is input, remove the check (ν) in the "Fault Selection
Calculation" checkbox.
When a color printer is concocted to the PC, you
can select color or monochrome printing to make a
hard copy.
You can select the leading display or delay display
for the phase difference of waveforms.
You can select a unit for the time displayed when a
waveform data is displayed.
You can select the primary value display or the
secondary value display for the measurement and
analysis values.
You can select whether the fault time is calculated
automatically at the same time with the waveform
display or not.
⎯ 118 ⎯
6 F 2 S 0 7 1 5