Displaying Rms Value - Toshiba RSM 100 Instruction Manual

■Displaying RMS Value

This part describes how to display the RMS values for 1 cycle before the active cursor position.
《Note for Operation》
● You can select the primary values or the secondary values for the RMS values.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Options)
《Operating Procedure》
① Display the active cursor at the measurement point.
② On the [Measurement] menu, click [RMS Value].
③ The RMS values of the channels are displayed.
･ The RMS values for 1 cycle before the cursor position are calculated.
･ You can update the values by moving the cursor.
⎯ 121 ⎯
6 F 2 S 0 7 1 5
2-9