Fisher & Paykel DishDrawer DD60SDFHTX6 User Manual page 29

Hide thumbs Also See for DishDrawer DD60SDFHTX6:
Table of Contents

Advertisement

Problem
Continuous
beeping
Intermittent
beeping
DishDrawer® will
not start
Excess water in the
DishDrawer®
Water marks on the
dishes
DishDrawer®
interior is stained
Dishes did not dry
No detergent
dispensed
Excessive motor
noise
Possible Cause
A fault has occurred.
DishDrawer® is in pause
mode.
Power supply is not
connected.
The drawer is not closed
properly.
Keylock or Childlock feature
is on.
button not pressed.
Drain hose(s) bent or
kinked.
Blocked filters.
Rinse aid depleted.
Rinse aid setting too low.
DishDrawer® overloaded/
incorrectly loaded.
Insufficient or no salt in the
water softener.
Some foods, like tomato
based products, may
stain the inside of the
DishDrawer®.
Incorrect loading.
Rinse aid depleted.
Rinse aid setting too low.
Eco wash programme used.
Detergent dispenser was
wet when loaded.
The filter plate and/or spray
arm is incorrectly placed.
No water in the motor area.
Troubleshooting
What to do
Refer to the 'Fault codes' section.
Close the DishDrawer® and press the
button.
Connect the power supply.
Ensure the drawer is firmly closed.
Turn the Keylock or Childlock off. Hold down
the
/
button until the light above the
/
button disappears.
Press the
button.
Straighten the drain hose(s).
Clean the filter plate/drain filter. Refer to the
'Care and cleaning' section.
Refill the rinse aid dispenser.
Increase the rinse aid setting.
Refer to the section on loading.
Ensure there is enough salt in the water
softener and/or increase the water
softener setting.
Pre-rinse dishes before placing in the
DishDrawer®. Alternatively, using the Rinse
programme after adding the dishes may
minimise staining.
Ensure the dishes are not nesting together.
Refill the rinse aid dispenser.
Increase the rinse aid setting.
Choose a standard wash programme.
Clean the dispenser and ensure the
dispenser is dry when adding detergent.
Refer to the 'Care and cleaning' section for
details on correct placement.
This usually occurs on the first use or when
the DishDrawer® has not been used for
long periods of time. Run the DishDrawer®
through a wash programme.
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents