Table of Contents
Advertisement
Quick Links
T W O - W A Y F M L E D A U T O M A T I C / M A N U A L
T R A N S M I S S I O N R E M O T E S T A R T E R
PS-4661TWE-FM
User Guide
It is the responsibility of the vehicle operator to ensure their
vehicle is parked in a safe and responsible manner.
a) Manual transmission: When leaving the vehicle, it is the user's
1.
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the
user's responsibility to ensure that the gearshift lever is in "Park" in
order to avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
It is the user's responsibility to ensure that the remote starter is
2.
disabled or put into valet mode before servicing.
Designed & engineered in Canada
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (EIRP) is not more than that required for successful communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user's authority to operate the equipment
Doc#: 110809
Rev:1.4
© 2011
WARNING
- PS-4661TWE-FM -
- FcN -
Canada
Advertisement
Table of Contents
Related Manuals for Directed Electronics PS-4661TWE-FM
Summary of Contents for Directed Electronics PS-4661TWE-FM
- Page 1 NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment Doc#: 110809 Rev:1.4 © 2011 - PS-4661TWE-FM - - FcN - Canada...
-
Page 2: Table Of Contents
Table of Contents Government regulations ........................4 Introduction with SmartStart™ ..................... 4 Using the Remote Control ....................... 5 Vehicle Presets ..........................6 Heater ............................6 Windshield Wipers & Radio & Headlights ..................6 Arming and disarming the starter kill (if installed) ............... 7 Remote-Starting Your Vehicle ...................... - Page 3 What is EncryptR™ Technology? EncryptR™ employs proprietary encryption software that sends unique codes from the remote starter to the ADS-TB or ADS-AL-CA bypass module that cannot be replicated or reversed with hi-tech equipment. The EncryptR™ communication exchanged between the remote starter and the ADS bypass module is best described as a “secret handshake”...
-
Page 4: Government Regulations
Government regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. -
Page 5: Using The Remote Control
Using the Remote Control Your remote starter is equipped with a 5-button multi-channel remote control. It can operate two independent vehicles equipped with a remote starter (see Multi-car operation section on page 16). The functions of the transmitter are as follows: 2-way LED remote LOCK: Locks the doors and arms the STARTER KILL (if installed). -
Page 6: Vehicle Presets
1-way companion remote (optional) LOCK: Locks the doors and arms the STARTER KILL (if installed). UNLOCK: Unlocks the doors and disarms the (Image as reference only) STARTER KILL (if installed). Activates the AUX 1 output if Priority Door Access is configured. TRUNK: Opens the TRUNK or activates the AUX 3 output. -
Page 7: Arming And Disarming The Starter Kill (If Installed)
Arming and disarming the starter kill (if installed) This added security feature will prevent the vehicle from starting with the Ignition key when the starter kill is armed. If the system was installed with the starter kill option, the vehicle will not be able to start with the key unless the system has been unlocked first or put into Valet Mode (page 10). -
Page 8: Remote-Starting Your Vehicle
Remote Starting Your Vehicle Setting Your Vehicle into Ready Mode If your vehicle has a manual transmission you must read the following indications. In order to start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready Mode, it cannot remote start the vehicle. -
Page 9: Driving Off
Driving Off With the vehicle running remotely, press the button to disarm the starter kill (if installed) and unlock the doors. Enter the vehicle and do the following: Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK position while the engine is running. -
Page 10: Valet Mode
Once the key is in the ON position, press on the brake pedal to put the transmission in gear. Pressing the brake pedal at this step will cancel the remote starter takeover. Drive off. If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as that used for Ready Mode (page 8);... -
Page 11: Panic Mode
To take the system out of Valet Mode Using the KEY (Ignition Valet Mode): Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the IGNITION/RUN and OFF positions 5 times until the parking lights flash twice. Turn the ignition OFF. -
Page 12: Extended Run Time
To enter Cold Weather Mode (1-way remote): Rapidly press AUX twice. The remote’s LED will start flashing. Press and hold until the parking lights will flash for 2 seconds, pause, and then flash 3 times. To exit Cold Weather Mode, do any one of the following actions: Open the hood. -
Page 13: Feature Confirmation Chart
pulse can be configured to activate certain functionalities such as rolling down the windows – Please refer to your installer to see if your vehicle is compatible with this option. Feature Confirmation Chart Feature LOCK UNLOCK TRUNK START/STOP Beep(s) Lock 3 flashes Unlock 3 flashes... -
Page 14: Safe Start
Safe Start This feature will eliminate accidental remote starts, e.g. when children are playing with the transmitter. Safe start enabled: If this feature is enabled, the user must press the button twice within 3 seconds to remote-start the vehicle. Swap start (2-way remote): If this feature is enabled; Press and release the AUX button. -
Page 15: Home Valet Tm " Mode
“Home Valet ” Mode If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if the vehicle is parked indoors there is no danger of it starting accidentally by remote control. If the vehicle has a manual transmission, it should be set into ready mode before activating the Home Valet™. -
Page 16: Multi-Car Operation
Multi car Operation This option allows the owner of two vehicles, both equipped with the same Remote Car Starter model, to control both systems with a single remote control. To control the second vehicle: Press TRUNK + LOCK buttons simultaneously: ----------------------------------------------------- LOCK Press TRUNK + UNLOCK simultaneously: ----------------------------------------------------------- UNLOCK Press TRUNK + START/STOP simultaneously: ----------------------------------------------------- START Press TRUNK + START/STOP simultaneously: ----------------------------------------------------- STOP... -
Page 17: Vehicle Status Request
Vehicle Status Request The status request feature allows the user to see the status of the vehicle i.e.: if the doors are locked or unlocked or if the vehicle is in cold weather mode, home valet mode, in valet mode or how much time is left in the run time cycle. -
Page 18: Status Request When The Engine Is Running
Status Request When the Engine is Running When the vehicle doors are locked: The LED # 1 will flash 3 times to denote that the vehicle’s doors are locked. When the vehicle doors are unlocked: The LED # 2 will flash 3 times to denote that the vehicle’s doors are unlocked. And: RUN TIME Beep(s... -
Page 19: Diagnostics - Parking Light Flash Table
Diagnostics – Parking Light Flash Table Parking lights flashes Description Doors locked. Trunk released. Start signal received from the remote. Runtime has expired. Doors unlocked. 2 fast Valet mode is deactivated. 2 slow Shutdown by remote. 3 slow Runtime is extended. 1 slow Æ...