To Start An Engine With A Weak Battery - Husqvarna 13 AWD Operator's Manual

7. When the engine has started release the igni-
tion key to neutral position.
Push the throttle control to the required speed.
For cutting 3/4 to full throttle.
WARNING!
Never run the engine indoors, in
enclosed or poorly ventilated
areas. The exhaust fumes contain
toxic carbon monoxide.

To start an engine with a weak battery

WARNING!
Lead-acid batteries generate
explosive gases. Keep sparks,
flame and smoking materials
away from batteries. Always wear
eye protection when around
batteries.
If your battery is too weak to start the engine, it
should be recharged.
If "jumper cables" are used for emergency starting,
follow this procedure:
IMPORTANT INFORMATION
Your mower is equipped with a 12-volt
negative grounded system. The other
vehicle must also be a 12-volt negative
grounded system. Do not use your
mower battery to start other vehicles.
To attach jumper cables
• Connect each end of the RED cable to the
POSITIVE (+) terminal on each battery, taking
care not to short against chassis.
• Connect one end of the BLACK cable to the
NEGATIVE (-) terminal of the fully charged
battery.
• Connect the other end of the BLACK cable to a
good CHASSIS GROUND, away from the fuel
tank and battery.
To remove cables, reverse order
• BLACK cable first from chassis and then from
the fully charged battery.
• RED cable last from both batteries.
18
– English
DRIVING
Jumper cables connection
STOP START
6007-007
8011-642