Maintenance; Maintenance Schedule - Husqvarna 13 Operator's Manual

The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.

Maintenance

Check the engine's oil level
Check the engine's cooling air inlet
Check the fuel pump's air filter
Check the steering wires
Check the brakes
Check the battery
Check the safety system
Check screws and nuts
Check for fuel and oil leakage
Change the engine oil
Clean the air filter's pre-filter (foam plastic)
Check the cutting unit
Check the tyre pressures (60 kPa)
Lubricating the belt adjuster
Lubricate joints and shafts
Adjust the brakes – Rider 11 and Rider 11 Bio
Check the V-belts
Check the transmission's cooling flanges –
Rider 13 and Rider 13 Bio
Check the transmission's oil level – Rider 13 and
Rider 13 Bio
Adjust the brakes – Rider 13 and Rider 13 Bio
Check and adjust the throttle wire
Clean the cooling flanges on the engine and
2,4)
transmission
Replace the air filter's pre-filter and paper filter
Replace the fuel filter
Replace the plug
1) First change after 5 hours.
machine lubrication should be conducted twice a week.
= Described in these instructions.
= Not described in these instructions.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cable is removed from the plug.
MAINTENANCE

Maintenance schedule

1)
2)
3)
3)
2) During dusty conditions cleaning and replacement should be more frequent.
4)
Page
before start
37
30
28
24
25
28
29
–
–
37
27
31
30
38
39
25
–
–
39
25
26
–
2)
27
26
28
Conducted by authorised service workshop.
•
•
Maintenance interval
Daily
in hours
mainte-
nance
25
3) For daily use of the
The parking brake is applied.
The cutting unit is disengaged.
50
100
21
English –