Using The Tire Mobility Kit - Hyundai Elantra 2013 Owner's Manual

Using the Tire Mobility Kit

1. Detach the speed restriction label
(0) from the sealant bottle (1), and
place it in a highly visible place
inside the vehicle such as on the
steering wheel to remind the driv-
er not to drive too fast.
2. Screw connection hose (9) onto
the connector of the sealant bottle.
3. Ensure that screw cap (8) is
closed.
4. Unscrew the valve cap from the
valve of the flat tire and screw fill-
ing hose (2) of the sealant bottle
onto the valve.
5. Insert the sealant bottle into the
housing (4) of the compressor so
that the bottle is upright.
6. Ensure that the compressor is
switched off, position 0.
7. Plug the compressor power cord
into the vehicle power outlet.
8. With the engine start/stop button
position on or ignition switch posi-
tion on, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to the Tire
and Wheels, chapter 8). The infla-
tion pressure of the tire after filling
is unimportant and
checked/corrected later.
Be careful not to overinflate the tire
and stay away from the tire when
filling it.
What to do in an emergency
CAUTION
Do not attempt to drive your
vehicle if the tire pressure is
below 29 PSI(200kpa).
could result in an accident due
to sudden tire failure.
9. Switch off the compressor.
10. Detach the hoses from the
sealant bottle connector and
OYN069018
from the tire valve.
Return the Tire Mobility Kit to its stor-
age location in the vehicle.
WARNING
Do not leave your vehicle run-
ning in a poorly ventilated area
for extended periods of time.
Carbon monoxide poisoning
and suffocation can occur.
will be
- Tire pressure
This
- Carbon
monoxide
6 23