If Engine Stalls While Driving; If The Engine Will Not Start; If Engine Doesn't Turn Over Or Turns Over Slowly; If Engine Turns Over Normally But Does Not Start - Hyundai Elantra 2013 Owner's Manual

Hide thumbs Also See for Elantra 2013:
Table of Contents

Advertisement

2. When the vehicle is stopped, turn on
your emergency hazard flashers, set
the parking brake and put the transaxle
in P (automatic transaxle) or reverse
(manual transaxle).
3. Have all passengers get out of the car.
Be sure they all get out on the side of
the car that is away from traffic.
4. When repairing a flat tire, follow the
instruction provided later in this sec-
tion.

If engine stalls while driving

1. Reduce your speed gradually, keeping
a straight line. Move cautiously off the
road to a safe place.
2. Turn on your emergency flashers.
3. Try to start the engine again. If your
vehicle will not start, contact an
authorized HYUNDAI dealer or seek
other qualified assistance.
✽ ✽ NOTICE
If there was a check engine light and loss
of power or stall, it is best if safe to do so
to wait at least 10 seconds to restart a
vehicle after it stalls. This may reset the
car so it will no longer run at low power
(limp home) condition.

IF THE ENGINE WILL NOT START

If engine doesn't turn over or
turns over slowly
1. If your vehicle has an automatic
transaxle, be sure the shift lever is in N
(Neutral) or P (Park) and the emer-
gency brake is set.
2. Check the battery connections to be
sure they are clean and tight.
3. Turn on the interior light. If the light
dims or goes out when you operate the
starter, the battery is discharged.
4. Do not push or pull the vehicle to start
it. See instructions for "Jump starting".
WARNING
If the engine will not start, do not
push or pull the vehicle to start it.
This could result in a collision or
cause other damage. In addition,
push or pull starting may cause the
catalytic converter to be over-
loaded and create a fire hazard.
What to do in an emergency
If engine turns over normally but
does not start
1. Check fuel level.
2. With the ignition switch in the LOCK
position, check all connectors at igni-
tion coils and spark plugs. Reconnect
any that may be disconnected or
loose.
3. If the engine still does not start, call an
authorized HYUNDAI dealer or seek
other qualified assistance.
6 3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents