Remote Sensor; Getting Started; Power Supply - Oregon Scientific BAR339P User Manual

7. MEM: View current, maximum and minimum
temperature
8. PROJECTION: ON / OFF switch
9. LIGHT: Backlight ON / OFF switch
10. DEMO WEATHER FORECAST: Select between
demo mode and weather forecast mode
11. Adapter socket

REMOTE SENSOR

1
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole: Reset unit to default settings
5. CHANNEL button: Select channel 1
BAR339P_M_EN_R1.indd 3
2
4
3
5
3

GETTING STARTED

POWER SUPPLY

Batteries serve as a back-up power supply. For
continuous use of projector and backlight, install
adapter. The socket-outlet shall be installed near the
equipment and shall be easily accessible.
NOTE will appear when power supply is not
connected.
To insert batteries:
1. Remove the batter y compar tment and inser t
batteries, matching polarities.
2. Press RESET after each battery change.
MEANING
LOCATION
Clock / alarm area Main unit batteries low
Outdoor / indoor
Sensor batteries low
temperature area
REMOTE SENSOR
To set up the sensor:
1. Open the battery compartment, and insert batteries,
matching polarities.
2. Place the sensor within 30 m (98 ft) of the main
unit using the table stand or wall mount.
6/21/07 2:08:01 PM