Remote Sensor; Getting Started; Insert Batteries - Oregon Scientific JW108 User Manual

REMOTE SENSOR

19
19. LED status indicator
20. Wall mount hole
21. CHANNEL switch
22. RESET: Reset the unit to default settings
23. Battery compartment

GETTiNG STARTED

iNSERT bATTERiES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (+/-).
3. Press RESET after each battery replacement.
JW108_M_EN.indd 4
20
23
22
21
Reset
1 2 3
REMOTE SENSOR
The main unit can collect data from up to 1 sensor.
To set up the sensor:
1. Open the battery compartment.
2. Slide the CHANNEL switch to 1, then press RESET.
3. Close the battery door.
4. Place the sensor within 98 ft (30 m) of the main unit
location on the exterior of the home at a height of not
more than 5 ft (1.5 m) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
4
LOCATiON
Clock/alarm area
Outdoor temperature
area
using the wall mount.
TiP Ideal placements for the sensor would be in any
MEANiNG
Main unit batteries
low
ensor batteries low
14-7-10 1:27